UPDATE: I adding more files of modified clips - 1,2,3,4 and angled ones that fit same sleeve, available in files
Also note the the 2 sleeves are different bit sizes - but fit same clip , a ~0.15mm diff in size.
Added a bit size test, 6.25mm,6.3mm, 6.35mm, 6.4mm - this will assist in choosing right sleeve size without printing everthing at first.

If you printed and like, comment which sleeve size worked for you.

Designed to keep your drill/screwdriver bits exactly where you need them—no bulk, no rattling, no digging around.

This clip holds a sleeve of 20 hex bits and snaps cleanly onto your multiboard.
Its less bulky than most out there, less time and material to print and no supports required.
For me, its also visually pleasings.

I made two orientations for printing (flat + angled) for the clip.

The angled version benefits from a brim, everything else prints as-is.
Your prefrence.

✔ Print-Ready

Print-in-place, zero supports

0.2 mm layer height

15% infill

PLA or PETG (your choice of filament)

✔ Two Sleeve Sizes

Bits are not universally the same size—so you get two inserts:

Small: ~6.3 mm (prints at ~6.2 for me) (toghether with clips)

Large: ~6.4 mm (prints at ~6.25–6.3 for me) (on seperate workspace)

Both sleeves fit perfectly into the same snap holder.

If modifications are needed, feel free to comment below

Let me see you makes
Feel free to see my other multiboard makes

Multiboard Folder